View Single Post
Old 02-07-2009, 01:33 PM   #2
Scoobie Steve
Scooby Specialist
 
Member#: 2289
Join Date: Sep 2000
Chapter/Region: Tri-State
Location: Bangor, PA
Vehicle:
1998 [email protected]
Subaru L Ver 6 STi Type R

Default

Looks like you need to wire in connector B40. You should be able to trace the RW wire from the test connector to the OBDII plug. If its not in the harness some where then you should have some wires cut and hanging out. I will take a look at my harness and see where the obdII wires run. IIRC when I flipped my harness I had to extend the obdII connector wires, you might want to look for the connector over by the ecu somewhere.

Here is some info on the test and read connectors. It applies to the svx but it may be similar.

http://www.wbx6.de/doc/selbstdiagnose_motor.pdf
* Registered users of the site do not see these ads.
Scoobie Steve is offline   Reply With Quote