View Single Post
Old 04-21-2005, 01:46 AM   #8
agterlik
Scooby Specialist
 
Member#: 41626
Join Date: Aug 2003
Chapter/Region: NWIC
Location: Mt Vernon, WA
Vehicle:
SPB We make people
quit teh internet

Default

The egt is in the stock uppipe and goes to the ecu....if you use a gutted/catless uppipe the sensor would get destroyed so ppl put a 2.2k ohm resistor into the plug that would normally connect to the sensor.....in other words since you are using a gutted uppipe you do not need to worry about it.....as for the 02 sensors the plugs on the o2 sensors for the wrx are different than for the rs....you could always cut the plugs and just solder the wires together but I do not know if the rs 02 sensor reads over the same range as the wrx one.
* Registered users of the site do not see these ads.
agterlik is offline   Reply With Quote