View Single Post
Old 10-20-2018, 01:47 PM   #19
Scooby Specialist
Member#: 253498
Join Date: Jul 2010
Chapter/Region: SCIC
Location: sOuL-CaLiFoRnIa


Ceramic coated and re-installed the ebay EL header using OE gaskets. I also used some heat tape on the nearby coolant lines and oil pan.

With no front bumper, I picked up this from a local. I'd come to realize it wasn't the right one for 02-03, as it was designed for 04-05.

The bumper fit, but was awkwardly snug and pushed forward a bit. It was extremely rough; I viewed it as a patch just to get to the next step.

Lacking seats, I decided to buy some buddyclub seat rails to pair them with some bucket seats I had in the garage.

Google hunting, I saw this and fell in love. It would be perfect to tie in the STI them hidden inside. Despite how cheap I wanted to be, I knew this was a must buy, in time.

Driverway Tingz. First test drive around the block went well. An alignment is highly necessary and the P/S needed some more fluid and to be bled. I spent the evening removing the old FRP bumper & support designed for a big wing in favor of an OE one; also sourced on offerup.

* Registered users of the site do not see these ads.

Last edited by JDMJNKY; 10-21-2018 at 09:09 PM.
JDMJNKY is offline   Reply With Quote