View Single Post
Old 06-04-2018, 05:58 PM   #1
Member#: 141043
Join Date: Feb 2007
Chapter/Region: MWSOC
Location: Cottage Grove, MN
2011 STI
black af

Default MAPerformance Stage 1+ Package for 15-17 STI Now Available!

2015+ STI Stage 1+ Package

MAPerformance is proud to announce the release of our Stage 1+ package for the 15+ STI’s! As some of you may be aware, MAPerformance has been providing OTS tunes developed in house for a few of our popular platforms ranging from Stage 1 tunes for stock vehicles, to vehicles equipped with our hard parts. With that being said, I can’t ignore the most common question I get on a daily basis…. “What intake works with your Stage 1 tune?” To answer that, we need to look at how an aftermarket intake can affect the calibration of both the factory tune, or an aftermarket tune.

It should be no surprise to the Subaru community that installing an aftermarket intake on these cars isn’t always as easy as bolting one on, and enjoying the immediate power increase and drivability. Since the EJ’s utilize a MAF sensor for load/airmass calculations, there are a few things that can affect how the car will respond with an aftermarket intake installed. From piping size (diameter and length), to MAF placement, can all have an affect on MAF readings. This is especially the case with our MAP intake, which utilizes a full 3” mandrel bent stainless pipe. With the larger pipe diameter and MAF housing, tuning will be required. Fortunately, MAPerformance has developed a tune specifically for the use of our intake system. The MAPerformance Stage 1+ tune will be free with the purchase of the Accessport and intake from us. Already purchased the Accessport from us? No problem. The tune will also be included with the purchase of the intake separately. Before we get to the dyno plots, let’s take a look at some of the features of the intake:
  • 304 Stainless steel mandrel bent pipe
  • Stainless steel heat shield
  • 6” Cone filter by Green Filters USA
  • 6” velocity stack
  • Intake silencer cap
  • All installation hardware included
  • Fabricated here in Minnesota!
  • Free OTS Stage 1+ tune included (91 and 93 octane available)*

*MAP’s Stage 1+ tune is to be used with the MAP intake only, and cars using the factory downpipe.

Now let’s take a look at the results below:
Car in testing is a 2016 STI using 93 octane fuel. No other modifications except the MAP intake and tune. Please forgive the “break” in some of the runs. Unfortunately we were having issues with our tach lead on these runs.

Blue line is completely stock
Red line is our MAP Stage 1 93 octane tune with stock hardware
Green line is our MAP Stage 1+ 93 octane tune with the addition of the intake

Feel free to email me or PM me with any questions at all!

Thanks for reading,
* Registered users of the site do not see these ads.
maperformance is offline   Reply With Quote