View Single Post
Old 02-14-2018, 10:10 AM   #7
Samurai Jack
Scooby Guru
 
Member#: 21145
Join Date: Jul 2002
Chapter/Region: NESIC
Location: Not in my own time
Vehicle:
2002 Enemy of Aku

Default

Quote:
Originally Posted by Rickyh View Post
If you had 30 psi on one cylinder and it still ran fine I would repeat the test to verify that it was correct.
Re-check all your hose connections and then, as stated above, re-do the compression test.

Do a dry test first and then do a wet test.

If the compression stays low from both the dry and wet test, could be a valve issue ( valves, valve seals, etc. ) or a ring/piston issue

If the compression improves when doing the wet test, then probably a ring/piston issue.
* Registered users of the site do not see these ads.
Samurai Jack is offline   Reply With Quote