View Single Post
Old 09-02-2007, 03:00 PM   #6
2.5SR40WRX
Scooby Newbie
 
Member#: 137474
Join Date: Jan 2007
Chapter/Region: MWSOC
Location: Chicago, IL
Vehicle:
2004 WRX Hybrid 20g
6-Speed 370/370

Default

Well I work at a machine shop here in Chicago and the largest buckets we have are .503's and I'm still off more than .010 almost all my clearances. P&L is the place that I had do my heads last time and whoever does their machine work adjusted the head by taking material off the stem of the valve instead of getting the right buckets to match the valves. Now I'm trying to use those same valves in my new setup and I'm having a difficult time. My fear is that I'm going to have to buy all new valves since they took so much off the top of them. This wasn't something done by P&L personally, I'm 100% not bashing them by any means. The work they do up there is great. So if .510 is as big as the buckets go then it looks like I need to get some new valves.
* Registered users of the site do not see these ads.
2.5SR40WRX is offline   Reply With Quote