View Single Post
Old 10-16-2015, 09:00 AM   #2
ajmillan
Scooby Newbie
 
Member#: 298536
Join Date: Oct 2011
Chapter/Region: South East
Location: florida
Vehicle:
2013 STI
Satin white

Default

Quote:
Originally Posted by ohm View Post
So after hacking up my front bumper in order to accommodate the DR525 FMIC, I wasn't completely satisfied with the edges of where I made the cuts. Though I sanded it down smooth, it still didn't look right to me.

I searched for some rubber edge trim that people may have been using to give it a cleaner look. Though Mcmaster-carr has a wide variety of styles to choose from, I was looking for something locally. A few guys recommended a 3M "L" style trim, but I couldn't locate this in retail stores. Thanks to Bardrcr, he found an edge trim that is thin enough to sit securely, and also has slight adhesion to keep it in place. The company is Cowles, and it is called "Edge Trim" in the color black. For $6.99 at a local Kmart you can't go wrong. I believe Advanced Auto Parts carries it too.

http://www.kmart.com/cowles-products...W004206199001P

I may take the bumper off again to apply the trim to the edges to make it uniform, but I think it looks good.




Did this ever melt on to the intercooler? Or did it hold up fine?
* Registered users of the site do not see these ads.
ajmillan is offline   Reply With Quote