View Single Post
Old 09-01-2006, 08:44 PM   #12
Richard L
Scooby Newbie
 
Member#: 85153
Join Date: Apr 2005
Location: Sussex England
Vehicle:
2004 Citroen Picasso
Silver

Default

Quote:
Originally Posted by runner19 View Post
Calvin

Excellent. Then I can use a N/C relay (change over) to open the hop switch circuit.

Thanks dude.
Since most (99.9%) of the controller output switches to ground when active. You can set your controller output switch to ground during startup (disabling the 2d) and off-ground when your want the 2d to spray.

You have to think logically and to act illogically. This will save using a relay and extra wiring. Just connect the FIA2's blue wire to your controller and try.

Richard
* Registered users of the site do not see these ads.
Richard L is offline   Reply With Quote