View Single Post
Old 01-16-2017, 10:41 PM   #9
satrya
Scooby Specialist
 
Member#: 5887
Join Date: Apr 2001
Chapter/Region: BAIC
Location: Fremont, CA USA
Vehicle:
2002 GDAA (bugeye)
797 (blaze yellow)

Default

Quote:
Originally Posted by car_freak85 View Post
I'm about to start retrofitting my JDM projectors and was wondering if anyone has the English FSM headlamp aiming procedure for these lamps. I saw the first half of the screen-grab in another (Depo lamp?) thread.
I would just follow the general alignment of the cutoff elbow being at least 2 inches lower at around 25ft away.

Also, what projectors are you going to use? TRS' Mini D2S 4.0 has gotten to a point where I think it makes much more sense than a TSX, and maybe even RX330. Whatever you choose, make sure you test them first to see if you need to adjust the shield etc. for the hotspot / shield height fine tuning. I'd also recommend considering a foreground limiter.
* Registered users of the site do not see these ads.
satrya is offline   Reply With Quote