View Single Post
Old 12-27-2012, 08:50 PM   #2
06SE
Scooby Newbie
 
Member#: 158925
Join Date: Sep 2007
Chapter/Region: MAIC
Location: NoVA
Vehicle:
12' Sport LTD
MBP

Default

Part 2:
Step 9: Pull out black piece which holds the headlight, bumper, etc. to the car. This will take some finagling and involve pulling the bumper forward a bit while trying to shimmy the part out. There are two objects which protrude out of the back of this which makes removing it a bit awkward.




Step 10: Remove two bolts and one pop-it which hold in the headlight. This can be done earlier in the process if you like but I like leaving them in as otherwise it can make step 9 a bit more cumbersome as the headlight has a tendency to move around a lot while trying to take out that piece.



Step 11: Pull the headlight from the car. You will probably have to do some shifting to get it out. This will also involve possibly pulling the bumper forward a bit. The headlight also has two dimples which need to be pulled out of holes (1 by the fender and 1 by the grill). Upon reinstall make sure these are in their correct spots.



Tip - If you disconnected your MAF sensor while pulling out the air box to gain additional room it will result in a check engine as well as other lights appearing on your dash. To resolve this turn the car on and off (with 10 seconds in between each) three times in a row and the lights will go off.

* Registered users of the site do not see these ads.

Last edited by 06SE; 12-27-2012 at 09:52 PM.
06SE is offline   Reply With Quote