Event: Dyno Tune
Location: Motion Lab Tuning (Charlotte, NC)
Ambient Temp: 40 F
Elevation: 900 ft. ASL
Weather: Cloudy / Rainy
Track and Conditions: N/A
Tires: Unknown
Car: 2002 Subaru Impreza WRX
Tuner: Todd @ Motion Lab Tuning
Dyno Info: Mustang 500
Peak HP at RPM: 264whp @ 4650rpm (SAE Corrected)
Peak Torque at RPM: 343ft.lbs @ 3550rpm (SAE Corrected)
Baseline hp/tq for a stock on same dyno: 180whp stock WRX
Target Boost: 21psi tapering to 11 psi
Target AFR: 11.8:1
Fuel: 93 octane unleaded
Engine/Power Modifications: 2.5L block, STi cams in 2.0L heads, '08 STi oil pump, Invidia 3'' TBE, Deleted / Ported TGV's, Stock in-take w/ K&N drop-in filter, Venair intercooler hose kit, Grimmspeed 3 port EBCS
Driveline Modifications: ACT heavy duty street clutch kit & resurfaced flywheel
Suspension Modifications: SPT Springs
Other Modifications: N/A
Yep. Baseline was run on a Cobb Stage 2 map (lower dashed lines). Our highest recorded run was 264whp 343wtrq but we didn't manage to save it. Anyway, the one below isn't too far off from our high numbers.
I will say that this was one of the best instances of a Cobb OTS map I had seen before. It actually ran a nice AFR all the way through. Normally they're really overly rich from my observations.
This set up was completely maxed out in terms of injector IDCs and turbo capacity. It has nothing left in it. When we saw the wheel torque get close to 350 the we were all pretty impressed.