View Single Post
Old 05-22-2020, 06:42 PM   #1
What could go wrong
Scooby Newbie
 
Member#: 448908
Join Date: Jun 2016
Default Bell housing inspection hole cover?

I have an 09 WRX 5mt that just had some major surgery done. When I went to clean the engine bay (long story) I noticed I could actually see my flywheel exposed behind the intake.

I am assuming there is a cover that is supposed to be there, but was not reinstalled by the shop that did the work.

I would like to get a new one as Iím a clumsy **** and I am absolutely certain if I leave it exposed I am going to drop something in the bell housing at some point.

I looked around a few places and couldnít find a PN that seemed to match the slot, any help tracking it down would be great. Also while Iím at it, are there any other covers on the bell-housing I should check? Thanks!
* Registered users of the site do not see these ads.
What could go wrong is offline   Reply With Quote