View Single Post
Old 10-28-2012, 08:32 AM   #49
Scooby Guru
Member#: 108051
Join Date: Feb 2006
Chapter/Region: Tri-State
Location: NY
2005 TickingTimeBomb
Jr tuned TT Sleeved


Originally Posted by AkumaMotorsports View Post
The orientation of the gate in relation to the turbo is what I was referring to. It should look like a 'Y', where the two legs of the Y represent the turbo and gate, so they get equal flow. It sounds like you have that under control. Did you consider going twin scroll? It might be pretty easy to convert the Up Pipe and then you could do twin 38MM MVS, and go with a twin scroll turbine housing. That might be a pretty cool project. Just a thought though.

I knew you would not use the AVCS on the AEM V1, so I assume it works well for your application.

I see that you got the 44mm on there. Did it alleviate the creep?

What are you shooting for with this project? Low 10s...maybe 9s'? That would be pretty nice. Either way it looks like it is fun to drive.

Once you get it sorted out, why don't you and Junior bring the car to Akuma. We can do a few dyno pulls to compare the numbers...Mustang V DJ. Obviously, there will be no charge. I could then figure out what correction factor I should set the dyno at to get it reading more in line with the rest of the community. Just a thought.



What's wrong with the AVCS on the V1? the control is unstable or just limited?

Also I don't know for sure but wouldn't single scroll be the best option for a drag car at this displacement/turbo size. What a/r is you back housing 1.06? Not sure you could obtain a twin scroll housing for the 67mm that will flow as well around the turbine and out the down pipe. Not that this car has much of an exhaust system

Any update on the beast yet man? I'm like a little kid waiting for candy at someones door step lol.
* Registered users of the site do not see these ads.

Last edited by spoolinsti05; 10-28-2012 at 08:40 AM.
spoolinsti05 is offline   Reply With Quote