View Single Post
Old 08-02-2012, 08:56 PM   #3
Scooby Guru
Member#: 53443
Join Date: Jan 2004
Location: Anchorage, AK
2001 LL Bean Outback


I would first check to see if voltage is getting to the blk/yel wire on the pin 10 of the controller. If that is good then you could move on towards the fuel pump. If you don't have power there then you move towards the power source. It is usually always best to check for voltage first when checking problems like this. Once you pin down the trouble area you can check resistances. You must remove power from the circuit when you check resistances.

Be aware that power for the pump after the controller is only on for a couple of seconds when the iginition is turned on and the engine doesn't start.
* Registered users of the site do not see these ads.
Cougar4 is online now   Reply With Quote