View Single Post
Old 08-10-2012, 02:16 PM   #20
chewbakarox
Scooby Specialist
 
Member#: 25478
Join Date: Oct 2002
Chapter/Region: SCIC
Location: I fart 15 psi.
Vehicle:
2003 WRX Sport Wagon
PSM

Default

Quote:
Originally Posted by Cougar4 View Post
The white wire will connect to the output side of fuse SBF-4 in the panel under the hood. It goes to the ignition switch input.

While checking the wire at the ignition switch see if you can find any signs that the wiring has been modified. Chances are that if something has been done it will be near that area.
Thanks. I will do this tonight. I was inspecting the ignition output wiring and there have definitely been some modifications done with the alarm. Assuming the white wire to the ignition input is good to go, what would be the easiest way to check for power/continuity with the ignition output wires? Also, which ignition output wires would need to be checked (only the green)?
* Registered users of the site do not see these ads.
chewbakarox is offline   Reply With Quote