View Single Post
Old 06-17-2013, 11:27 PM   #31
prezarevo
Scooby Specialist
 
Member#: 266930
Join Date: Dec 2010
Chapter/Region: Tri-State
Location: Pennsylvania
Vehicle:
2004 WRX
PSM

Default

1. Remove valve cover
2. Get 1 1/8" wrench
3. Crank up air compressor
4. Place and hold 1 1/8" wrench on end of cam inside of head and firmly hold steady.
5. Apply good 10 mm bit and an ass slamming impact gun to cam bolt ( hold straight)
6. Tell your self " damn i'm good " because you easily removed that bolt.

Dont assume any impact will break these free. A good slammer will free those bolts up in a matter of 6-10 hits. And as someone said " get a good bit". Look into nitro-cat impact guns. They're a bit expensive but a few more dollars will save you lots of dollars.
* Registered users of the site do not see these ads.
prezarevo is offline   Reply With Quote