View Single Post
Old 09-21-2018, 10:55 PM   #43
Dash_Martino
Scooby Newbie
 
Member#: 78728
Join Date: Jan 2005
Chapter/Region: Tri-State
Location: Jim Chunk, PA
Vehicle:
04 STi
PSM

Default

After getting the motor in, I discovered that my clutch wouldn't mount to my throw out bearing thanks to the lame two-piece hub ring that broke on installing the motor. Unfortunately this meant that the motor had to come out again. Opted to get an ACT Monoloc:
https://i.imgur.com/WIcl0El.jpg
https://i.imgur.com/Nj85dx5.jpg
Highly recommended. If doing a clutch install, pony up and pick one up, totally worth it for the peace of mind.

Motor is in. Again.
https://i.imgur.com/rABmVBP.jpg
* Registered users of the site do not see these ads.
Dash_Martino is offline   Reply With Quote