View Single Post
Old 02-25-2008, 11:56 AM   #1
farrell
Scooby Specialist
 
Member#: 47746
Join Date: Nov 2003
Location: east stroudsburg PA
Vehicle:
2000 Impreza 2.5 RS
silverhorn

Default wierd engine install question

ok so i got me new engine in the car and mounted to the trans. But the bolts are not lining up with the holes for the motor mounts to go in. its sitting on the subframe, and is about 1/4 inch away from dropping right in to the holes. does ont have much room to push back. any tips to getting this sucker in? after i get it in, its just finishing up a few things and should be good for start up.
* Registered users of the site do not see these ads.
farrell is offline   Reply With Quote