View Single Post
Old 12-16-2009, 07:29 PM   #4
Scooby Guru
Member#: 99442
Join Date: Oct 2005
Chapter/Region: International
Location: Man of Mystery
2006 SGM STI
I'm on CORN YO!


haha, or cardboard. I am just good enough I only need to do it once. If he is making 1 for his car If he is making 1000 of these to sell then things would be different.

1. use a scrap piece draw on it with a pencil (20 minutes)
2. use the plasma cutter to cut out out (10 mintes)
-2.5 Test fit
3. grind it all smooth (20 mintues)
4. weld the flange on the end (15 minutes)
5. Drill a couple bolt holes (10 minutes)
-5.5 Test fit
6. paint it. (30 minutes including dry time)
7. BAM! it's done! Install it (10 minutes)

It shouldn't take more than 3 hours I am guessing
* Registered users of the site do not see these ads.
medamullet is offline   Reply With Quote