View Single Post
Old 11-26-2017, 05:44 PM   #4
challeen42
Scooby Newbie
 
Member#: 472151
Join Date: Aug 2017
Default

The oil that I use in the block is 5w 30 but the oil I used in the cylinder and head was 5w 20 to see if anything was leaking. I was thinking it could still be a bent valve I'll check that tomorrow. The rings and pistons were all perfectly fine and the pressure gauge did kind of move every few turnovers but that was it. The temperature was around 50 degrees F when I did the test as well. I have all the parts to finish the rebuild now, but I don't know that I want to finish it put it back in just to have to pull it out again because the problem isn't fixed.
* Registered users of the site do not see these ads.
challeen42 is offline   Reply With Quote