View Single Post
Old 03-21-2016, 07:29 AM   #360
makipsee
Scooby Newbie
 
Member#: 150181
Join Date: May 2007
Chapter/Region: Tri-State
Location: central islip, ny
Vehicle:
2006 STi
wrb

Default

Quote:
Originally Posted by whiterabbitrexy View Post
i think ill just give up while im a head ..... was reading on Dwell timing and if its off a bit i can have a big mess.....but was reading some where else that all OEM Subarus should have the same Dwell ? and im completely lost now because i thought rob was doing a single coil pack to multi coil on plug conversion but he already had that old phase 1 multi coil on plug so i understand where his pigtail plug was connecting too but now if i was to do that where do i connect the pigtail plug ?

thanks for the reply makipsee but again im still not on the same page with u ... connect pin 1 and 6 and that would take 2 cylinders of the pigtail from the cop? ? and connect pin 2 and 5 and that will take/control the other 2 cylinders ?
i have had this setup on my car for about 2 years with no issues. Yes pin1 would be the trigger from the ECU and you would connect that to pin6 which goes to the coil you would have to make a tee so that it goes to cylinders 1 and 2. Then connect pin2 to pin5 and again tee that and that would go to cylinders 3 and 4.

EDIT:: i was wrong i have had this for 4 years lol https://www.youtube.com/watch?v=tHrSy6T8c_4
* Registered users of the site do not see these ads.

Last edited by makipsee; 03-21-2016 at 07:31 AM. Reason: edit
makipsee is offline   Reply With Quote