View Single Post
Old 10-15-2013, 03:59 PM   #14
Von_holbrook
Scooby Newbie
 
Member#: 355965
Join Date: May 2013
Chapter/Region: South East
Location: Knoxville TN
Vehicle:
2003 2.1 WRB Bugeye
WRB+Gunmetal Volk's

Default

I didn't install the TOB like this. I put it on the forks and shaft first then clicked it into the plate after the motor & trans were together. But I had to unbolt the slave cyl from the trans to get everything lined up. The pin inside the slave cyl seemed to stop the fork from lining up to the holes for the shaft that goes through the fork.
* Registered users of the site do not see these ads.
Von_holbrook is offline   Reply With Quote