View Single Post
Old 01-21-2012, 04:20 PM   #84
0BlueSTi4
Scooby Newbie
 
Member#: 98955
Join Date: Oct 2005
Location: Los Angeles, CA
Vehicle:
2011 WRX Hatch
White

Default

Quote:
Originally Posted by sniper913 View Post
Just so people installing the HID's on the 08-11, you don't need to drill the cover. I don't get why people keep on like to drilling the back cover to fit the HID's. If you guys take off the cover, feel out the inside of the light, u will know there are holes big enough to fit any wires through at the bottom, all wires can go through there instead. Just my 2 cents.
Hmm...I just spent a very long time looking inside and around the light but can't seem to find any holes big enough for wires. The only thing I could locate was the stock grommet at the bottom of the light but its wedged pretty good in there and I am not sure how you can run wires through it without ruining it. At this point I think the easiest thing might be to drill a hole but if there is a more elegant solution I would like to know what it is. Thanks in advance!
* Registered users of the site do not see these ads.
0BlueSTi4 is offline   Reply With Quote