View Single Post
Old 11-25-2021, 10:54 PM   #2
Aphex28
Scooby Guru
 
Member#: 11506
Join Date: Oct 2001
Chapter/Region: NESIC
Location: Dracut, MA
Vehicle:
2010 Legacy GT
1999 10AE Miata

Default

Definitely possible, it would take fabwork to either make it out of fiberglass or wood as well as extending the wiring to your head unit, hazard switch and such would be easy enough. But there would definitely be a couple challenges in terms of the shift linkage as well as the HVAC controls for your car are controlled by cables to the blower motor & heater core. Turning it on an angle may mess up it's geometry and make the dials hard to use.

Not really something an amateur would take on without prior fabrication experience. Judging by the nature and tone of your question, it may be more cost than what you'd end up with.
* Registered users of the site do not see these ads.
Aphex28 is offline   Reply With Quote