View Single Post
Old 01-13-2019, 09:38 PM   #2
Blktrax
Scooby Specialist
 
Member#: 220971
Join Date: Aug 2009
Chapter/Region: South East
Location: West, NC
Vehicle:
2002 WRX 224K Mi.

Default

Negative - your fobs require dealer programming.

REGISTRATION OF KEYLESS TRANSMITTER WITH SUBARU SELECT MONITOR

NOTE:
• A maximum of four keyless transmitter can be registered for each individual vehicle.
• When replacing or adding the keyless transmitter, new registration of transmitter is necessary.

1. Connect the Subaru Select Monitor to the vehicle.
2. Turn the ignition switch to ON.
3. From the «Main menu» of the Subaru Select Monitor, select {2. Check individual system} → {Keyless unit mode} → {1. Transmitter ID registration}.
4. Input the 8-digit ID number attached to the plastic bag of the keyless transmitter or on the circuit board inside the transmitter, from left to right, then press the [Enter] key.
* Registered users of the site do not see these ads.
Blktrax is offline   Reply With Quote