View Single Post
Old 01-30-2014, 08:40 PM   #162
Florin1
Scooby Specialist
 
Member#: 163625
Join Date: Nov 2007
Chapter/Region: NWIC
Location: Lynnwood, Wa.
Vehicle:
91 Legacy SS
Silver

Default

Bumping this thread since the OP seems to be gone. Have an AVCS question.
After reading the thread, I got a bit confused on what I need to do wiring wise. I bought a jdm engine harness, and I also bought an avcs harness like OP had from another member that has been prepped. My car is an 02 wrx manual. I'm following the ds1 write up but now I'm wondering if I'm doing too much. Last night I got as far as page one. The one on moving pins 4 5 10 11. I also added 6" pigtails to pin 2 3 9 14 15. These are not yet soldered to anything. I'm worried about pin 14 because it says shield common ground. Not sure what that means. So my question is, do I need to follow the ds1 instructions all the way, or do I not, since I have the harness.
* Registered users of the site do not see these ads.
Florin1 is offline   Reply With Quote