View Single Post
Old 03-01-2008, 04:25 AM   #25
mikeis300
Scooby Newbie
 
Member#: 149526
Join Date: May 2007
Chapter/Region: NWIC
Location: portland metro area
Vehicle:
2002 aps dr65 hybrid
9.1x1 built block/heads

Default

Quote:
Originally Posted by WRFX View Post
2007 STi Cluster in a 2007 WRX

  • Trim the (A) green plug so it can slide on.
  • Move the B28 wire to B16. (Cruise)
  • Ground B4 pin (Diff light)
  • Cut the C9 wire (buzzer)
  • (Dimmer)-Connect a potentiometer between pins b20 and b22 on the cluster. The wrx harness does not have any connectors on these pins so all I did was shove the ends of the wires into the empty slots and secured it.

    With the headlights turned on you lower the brightness of the cluster until it makes a sudden drop in light (this is the night setting)....when you turn the headlights off the cluster goes back to the brightest setting. This is the potentiometer I used http://www.radioshack.com/product/in...entPage=search
why buy a potentiometer from radio shack when you dont need one? why wouldnt you just use the factory controls on the steering colum?
* Registered users of the site do not see these ads.
mikeis300 is offline   Reply With Quote