[xluben]

More updates:

Originally Posted by xluben

Unicorn fitting arrived. 3/8" NPT to -12 AN.

Originally Posted by xluben

I made sure to keep them near the compressor housing instead of the turbine or center section. I had the main electrical harness and some vacuum lines sitting on the sompressor housing on my last rotated setup and they were fine, so I hope this will be OK. I'll also have a turbo blanket on the turbo. If I'm way off base, let me know.

More side angle showing the hoses next to the compressor housing:

Originally Posted by xluben

Here's another shot that's even more from the side to show how I tried to keep the hoses away from the heat as much as I could.



You can also see the blanket installed on the turbo and that I cut down the downpipe/exhaust dump.

I hacked it off with my angle grinder and then Fobia cleaned it up and made it pretty with his belt sander.

* Registered users of the site do not see these ads.