View Single Post
Old 04-21-2006, 02:40 PM   #4
quezanart
Scooby Newbie
 
Member#: 83072
Join Date: Mar 2005
Chapter/Region: Tri-State
Location: Philadelphia, PA
Vehicle:
2016 WRX
Lapis Blue Pearl

Default

Well wiring the full color gauges should be quite simple. You really only have 3 wires that need to be hooked up, red (+ ignition), white (+ illumination), and black (- ground). The brown wire you don't end up using at all. You can find a place to hook all three of these wires up back on the radio wire harness. There should be a two wire (yellow and black) harness back there that is used for the OEM gauge pack. This can be used to supply the ground connection and the illumination + (yellow +, black -). As for the ignition +, on the radio wire harness find the solid red wire and use that as the ignition + wire. After that it's just plugging in the Omori harness to the color control box, the gauge, and the sending unit.

Any questions or need for further clarification feel free to PM me as i have a set of 3 52mm Omori Full Color gauges myself.

-Dan
* Registered users of the site do not see these ads.
quezanart is offline   Reply With Quote