View Single Post
Old 10-29-2013, 03:43 PM   #24
Concillian
Scooby Guru
 
Member#: 4414
Join Date: Feb 2001
Location: Dublin, CA
Vehicle:
2002 WRX Sedan
Midnight Black

Default

Quote:
Originally Posted by Concillian View Post
- I had to cut the large one piece Process West silicone hose to shorten the elbow for the slightly different location of the compressor output. The joiner needed to be really short, and I didn't have room for a 3" long joiner with rolled edges on both ends. I had to chop one up, and used a completely smooth joiner. It worked for a long time, but blew apart a few weeks ago. I got it back together using one rolled end and a double clamp on the flat end. It held up to a lot of yanking and twisting, so it should hold indefinitely now.
Well, it popped off this morning... Back to the drawing board. I don't know which end popped off. Hopefully the flat end and I can makeshift a bead. I may need to buy a new Y-hose if it's the other end. Was hoping to avoid that since they're nearly $100.
* Registered users of the site do not see these ads.
Concillian is offline   Reply With Quote