hey guys, i have been planning on boosting my car since pretty much day one. I have done countless hours of research, and think i am finally ready to start the project. i plan to do this in two stages..
.first stage. turbo kit installed on current block 5-8 ponds of boost
.second stage. swap in built block, new clutch...turn up boost.
.goals.
around 350 hp give or take
daily driver, i want it as reliable as possible
now for the build
.engine.
let me know if there is anything that would be better, or that i am missing this is the part of the build that i have the least experience with, and am most concerned about.
forged pistons
sti rods*
sti oil pump
dual springs/ titanium retainers*
delta cams*
acl race bearings
.fuel system.
walboro fuel pump*
modded wrx injectors*
.turbo/exhaust.
Precision t3/t04e 60trim*
modded 3" ebay turboback*
borla headers*
custom up pipe*
custom dp extension*
Greddy Type-S bov*
ebay fmic*
custom intake
Tail 44mm EWG*
oil drain/feed lines*
.e/m.
Cobb accassport*
.miscellaneous.
random hoses
soo... i want everyone to nitpick at anything you see in my build that might be a problem, and let me know if there is anything i may have missed. and i do not want to hear a single word about just selling the car, or just doing a swap, i know that normally is the cheaper route but it will not be any cheaper in this case.