View Single Post
Old 07-16-2019, 12:15 AM   #1
MortonCharbo
Scooby Newbie
 
Member#: 487057
Join Date: Jun 2018
Chapter/Region: BAIC
Location: California
Vehicle:
2002 WRX Wagon
PSM

Default Horn/hazard fuse pops as soon as I plug it in.

I installed sharptones and they worked until I went out for a drive. I checked the fuse and sure enough, it was blown. Put another in. Tested it and it worked. As soon as I started the engine, that fuse popped.

Now as soon as the fuse makes contact with the socket, pop! First off, I don't know what caused the behavior to change slightly. Second off, I don't know what's causing the problem in the first place.

I wired the relay using a combination of instructions I found on different forums. I've checked my wiring, and the existing wiring, and couldn't find any pinches or shorts.

I read somewhere that the relay may be mislabeled. Is this true? I can't find the thread that mentioned it.
* Registered users of the site do not see these ads.
MortonCharbo is offline   Reply With Quote