View Single Post
Old 10-22-2019, 07:40 PM   #88
jimbobzilla
Scooby Newbie
 
Member#: 505907
Join Date: Sep 2019
Location: FL
Default

Hey snp I hope your doing well.
You Have to use the John Guest fittings so you can insert the probes. The fitting fits the probe, I mean you could glue the probe in but you would not be able to change it if it failed.
To recap.... I taped the 3/4" scd 40 PVC to fit the John Guest probe fittings and sealed the fittings in place with J B Weld 2 part epoxy.
I will Give you a bit of advice......... If your water is high in PPM'S you will burn through resin quicker than you can order it off of amazon!!!
I am using my condensate water from my air conditioning unit.
My house water is 230 PPM, the A/C water is about 16 PPM.
I hope this helps, jimbobzilla.
* Registered users of the site do not see these ads.

Last edited by jimbobzilla; 10-23-2019 at 02:09 PM.
jimbobzilla is offline   Reply With Quote