View Single Post
Old 01-07-2021, 10:07 PM   #20
spoolinsti05
Scooby Guru
 
Member#: 108051
Join Date: Feb 2006
Chapter/Region: Tri-State
Location: NY
Vehicle:
2005 TickingTimeBomb
Jr tuned TT Sleeved

Default

So I went through the manual and tested my wires going to the imm ecm and what I found was pin 15 and 25 have like 75 ohm resistance also if I check voltage it's getting 6v obviously no continuity..

So I'm thinking jr didn't swap the wires correctly for the test mode connector. I'm gonna check that but having a hard time because the ecu pin-out doesn't list color codes. So I'm sitting through sections of the test mode connector wiring and other 5 pins to get the colors and going back to the pin-out and writing them all down.

Worst case they're correct I suppose that wouldn't be worst case..

I was thinking of just snipping the grounds from the loom and grounding them all on external from the loom because I really don't want to take my dashboard out and dip into a 500 wire loom to trace the short if that is even the case..

Thoughts?
* Registered users of the site do not see these ads.
spoolinsti05 is offline   Reply With Quote