View Single Post
Old 02-07-2013, 02:39 AM   #1
ccbremech
Scooby Newbie
 
Member#: 286915
Join Date: Jun 2011
Location: Victorville CA (SoCal)
Vehicle:
2004 STI
BLUE

Default ECUFLASH wont read ECU, now car wont start?

I tried to read my ECU VIA ECUFLASH and it would not read it. Just kept saying "Interface closed." so then i tried to start the car and nothing. Electrical turns on and off and the car can be taken in and out of test mode when connecting the green test mode conectors, But the car will not turn over. Any ideas here? Any help would be greatly appreciated.

Side note: i was able to datalog VIA ROM Raider Before the read and it worked fine.
* Registered users of the site do not see these ads.

Last edited by ccbremech; 02-07-2013 at 03:05 AM.
ccbremech is offline   Reply With Quote