View Single Post
Old 02-28-2018, 01:40 PM   #2
That_Boosted_Life
Scooby Newbie
 
Member#: 422693
Join Date: Jun 2015
Chapter/Region: Tri-State
Location: Buffalo,NY
Vehicle:
2016 WRX Premium
Lapis Blue Pearl

Default

I've had a similar issue with my lower doors, rear quarters, and entire trunk and rear bumper stop beading. I applied my first coat in late august but noticed those areas starting to not bead as well and decided to coat the entire car again in early october as I had bought the 20cc syringe. The road salt around me seems to affect it most. I did hand wash two weeks ago and was able to get the water to sheet off the lower doors and rear of the car, but it no longer beads. Car must still be protected as it still looks glossy and was easy to wash the layered road salt on the car.

I did work on a 1'x1' section of lower door for a few minutes. Washing the spot 3 times. The first just to ensure it was clean, then the second and third time with added pressure. I was able to get it so somewhat bead when misting it with the hose, but it doesn't run off like it did when the coating was initially applied.
* Registered users of the site do not see these ads.
That_Boosted_Life is offline   Reply With Quote