View Single Post
Old 04-15-2011, 12:00 PM   #11
KOJAK-02-WRX
Scooby Specialist
 
Member#: 208052
Join Date: Apr 2009
Chapter/Region: MWSOC
Location: Southern Indiana
Vehicle:
2004 SGM FXT-6speed
*SOLD* 02 PSM WRX

Default

Quote:
Originally Posted by Storm View Post
I think aluminum is going to stand up as well, if not better than Delrin (other than the recovery capabilities of plastic). I'll know soon enough if they develop slop in the spacers. Bolt sizes are M12 for the front inner pivots and M14 everywhere else.

Jay
Well I think I may drill out the front to fit the M14 so I can have the same all around. Seems like there is a lot of slop in the mounting holes so M14 might work without drilling.

You don't happen to know the diameter of the bolt that goes through the lateral links and knuckle do you? I'm sure it is bigger then 0.56 so I will just drill out my spacers to match but would be nice to know ahead of time.
* Registered users of the site do not see these ads.
KOJAK-02-WRX is offline   Reply With Quote