THANKS!!
I did a manual check as well ....10 full turns of the rear tire in neutral resulted in ~31 turns of the driveshaft so a low 3.1 ish reading .....close to the 3.273 ratio.
How to decode the original transmission code TG5D7CVDBA
I can find a JDM TGC7CVDBA is this a equivalent swap? Only difference is D Vs. C..?
Looks like the 5 transmission gear ratios are correct 1/3.54, 2/2.264, 3/1.471, 4/1.0, 5/0.834 and FR of 3.273
Note factory trans has harsh shifts and is getting a turbine sensor fault but I believe only replacement is a Vbody at $900.00+ so a JDM swap is low miles and hope it is a proper match. Does the Si-Drive bring in any other issues to check on with the JDM trans..?
Again THANKS!!!
Joe