View Single Post
Old 04-10-2004, 03:21 PM   #3
Scooby Newbie
Member#: 42249
Join Date: Aug 2003

I took off the back wheels (both had leaks) and only had to turn 1/4 turn and they were loose. I wiped all the excess off then turned 1/4 and then 1/4 more...probably put about 5 to 10 ft pds. Tested the brakes with the wheels off and I don't see any leaks. I think there might have been a drop in the tip that seeped out rather than a leak around the threads.

I dried up the front one and tested the brakes and I didn't feel anymore fluid up there either. Of course, this was all done with no load, just parked in the garage so I'll check again tomorrow.

It kinda makes sense though, they were tighter and tighter as I went from PR, DR, PF, DF...driver front was the one with no leak.
* Registered users of the site do not see these ads.
ForesterXT04 is offline   Reply With Quote