View Single Post
Old 01-14-2021, 01:54 PM   #1
Scooby Specialist
Member#: 310506
Join Date: Feb 2012
Chapter/Region: South East
Location: Florida
2005 WRX STi

Default Removing Stock Fuel Lines to Tank

Hi folks,

In the process of running -8 AN feed and -6 AN return lines from the engine bay to the tank. I've got a Radium double pump hanger in place already, and am going to add some ORB -> AN fittings into the hanger.

My question is, what are other folks doing about the existing rubber/hard lines that go from the tank -> engine bay?

Specifically, the feed and return lines.

Trying to figure out if I should just cut the rubber lines in the tank to make room for fittings and just route the SS lines around them, or if I should try removing them from the car altogether.

My plan is to route the lines strategically under the car and make sure they're covered up.
* Registered users of the site do not see these ads.
BeastianSTI is offline   Reply With Quote