View Single Post
Old 01-22-2021, 09:28 AM   #3
Scooby Specialist
Member#: 310506
Join Date: Feb 2012
Chapter/Region: South East
Location: Florida
2005 WRX STi


Just to leave a little update here.

I managed to get the old lines out, at least partially. The lines go from the top of the fuel pump hanger, across the top of the tank and then up into the cabin (under the driver side of the rear seat. After that, they go up the driver side, behind the insulation and though another gromet which is at the firewall.

Wow, that was a major pain to get out.

I ended up cutting the lines into a few separate sections. The hardest part was finessing the ends of the lines through the grommet/firewall and out.

For anyone else looking, if your fuel pump hanger is behind the rear seat, you CANNOT route the new lines across the top of the tank. The old lines are stuck there (mounted to the top of the fuel tank).

My plan is to use a 45* AN fitting on the feed/return @ the hanger, come up into the trunk and then back down through the cross-over cover on the driver side of the trunk.

From there, you can route the hoses under the car, under the plastic skid plate and up to the front of the car.

Still working on it currently, but thought this would be useful for anyone else trying to replace the stock lines
* Registered users of the site do not see these ads.
BeastianSTI is offline   Reply With Quote