View Single Post
Old 11-16-2012, 10:47 AM   #13
Blouchturbo
Former Vendor
 
Member#: 119764
Join Date: Jul 2006
Location: Lebanon,PA
Vehicle:
2006 STi
WRB

Default

You wanted to buy a actuator that may not have fixed your issues. We advised against this. I spoke with the stop doing to install to test the actuator base pressure to see if there was an issue. All turbos are tested and calibrated to 18psi with preload when the leave BPT so the higher pressure indicated more pre-load was added to the actuator or maybe damaged. All we needed is a test of the actuator to verify base pressure. Sorry you had a bad experience but we were never rude to you.
* Registered users of the site do not see these ads.
Blouchturbo is offline   Reply With Quote