View Single Post
Old 04-30-2017, 07:04 PM   #24
Dash_Martino
Scooby Newbie
 
Member#: 78728
Join Date: Jan 2005
Chapter/Region: Tri-State
Location: Jim Chunk, PA
Vehicle:
04 STi
PSM

Default

Next up were the heater hose lines that run from the back of the motor to the firewall to supply the heater core. The clamps on these were pretty rusty so the screwdriver just chewed apart the screws. If you're stuck, grab an 8 mm socket, that will take the clips off well.

http://i.imgur.com/1s77qLL.jpg
http://i.imgur.com/0e3r1LZ.jpg

Be prepared for a lot of coolant to spill!

Next up, two bellhousing bolts on the upper transmission on the passengers side. Much easier to reach than the tough ones underneath the car. Still used a breaker bar.

http://i.imgur.com/To00r75.jpg
* Registered users of the site do not see these ads.
Dash_Martino is offline   Reply With Quote