View Single Post
Old 11-20-2019, 12:43 PM   #24
amiexploited
Scooby Newbie
 
Member#: 251061
Join Date: Jul 2010
Chapter/Region: SCIC
Location: riverside, CA
Vehicle:
18 Trek 6mt,
garage queen 15 WRX 6mt

Default

Quote:
Originally Posted by KingBugeye View Post
Thank you its just hard to find clear information on it, I looked at the pictures and that part seems pretty straightforward.
Does the adapter you have take care of the amp wire and the speaker wires or is it only to adapt the speaker wires without splicing?
The adapters I have plug into the car's harness. I originally cut the speaker wires from the adapter and installed the RCA adapter. That didn't work right for me so I soldered them back to the harness/speaker level output. It's been a while since I looked at it but it should be both the 10 pin harness and the 26(?) pin. Once you have it all out it's not too complicated. I want to go back in and wrap all the wires in tesa tape.
* Registered users of the site do not see these ads.
amiexploited is offline   Reply With Quote