View Single Post
Old 09-30-2005, 12:56 PM   #47
InfamousDX
Scooby Guru
 
Member#: 25413
Join Date: Sep 2002
Chapter/Region: Tri-State
Location: North NJ
Default another question

Is there a diagram or instructions showing which wires are which coming out of the ECU (specifically the knock/coil pack wire cuz I don't know which one that is).

EDIT: Also let me ask this (if it hasn't been already covered)... what is better for monitoring knock. The knocklite wired into the factory knock sensor or a separate Bosch knock sensor bolted onto the block (same place as factory but on pass. side of the block)???? I thought the factory knock sensor stops listening after a certain RPM?
* Registered users of the site do not see these ads.

Last edited by InfamousDX; 09-30-2005 at 01:05 PM.
InfamousDX is offline   Reply With Quote