View Single Post
Old 07-31-2020, 06:52 PM   #1
defury
Scooby Newbie
 
Member#: 428480
Join Date: Aug 2015
Chapter/Region: W. Canada
Vehicle:
2003 Jdm Forester
Silver

Default Is this rod knock (Video)


You can hear the noise slightly better near the end (fans kicked in mid recording) the engine was hot as I had just been driving for 30 minutes, this is why I used the throttle to really rev the engine as the cable was to hot to hold.

Since I've taken delivery 11,000km ago the vehicle has had 3 oil changes all with motul xcess 5w40, the car consumes no oil, the timing belt and tensioners/pullys and water pump were all done, AC compressor rebuilt, cam seals checked, valve cover gaskets replaced (began sweating no real leak caught it early) and cams and cam gears/avcs sensors inspected. No boost leaks recently tested, knock sensor recently replaced to diagnose Phantom ecu knock, tech heard no real engine knock with mics hooked up to the block while driving.

Coolant temp in this video is 190f and the oil was checked and was full before recording.

I see no reason this would be rod knock but there's definately a low hollow knock from something. There's also a ticking from the valve train, I need to adjust the lifters so that's not the noise I'm referring to.

Thoughts?
* Registered users of the site do not see these ads.

Last edited by defury; 07-31-2020 at 08:54 PM.
defury is offline   Reply With Quote