View Single Post
Old 01-09-2008, 06:26 PM   #296
Scooby Specialist
Member#: 114730
Join Date: May 2006
Chapter/Region: SWIC
Location: Albuquerque, NM
2006 WRX Limited Wag
[email protected]


Originally Posted by Rickyh View Post
Facility: Engine Logics in Houston
Type of Dyno Dynamics
Baseline # for a stocker at the dyno:
Fuel:93 octane
Target AFR:
SAE Corrections:
Peak HP at RPM: 298 @6300
Peak Torque at RPM:[email protected]
Mods: td05 20g7cm 750 deatchwerks ebay fmic, catless up/down, apexi gt spec, act streetlight flywheel blah blah blah.

I could only boost up to 18 psi because the damn cheapo turbo inlet I had kept collapsing. as if on cue at 6300 it would suck down and boost would drop like a rock. I am gonna get an aps inlet and go back for a tune. I have read that stock wrx's dyno at around 140-150 on that dyno so I don't feel too bad.

Try replacing your intake before you replace the inlet. I had the same problem and switched to a short ram and now I can run 25psi without collapsing on my Dominator 3.
* Registered users of the site do not see these ads.
06rexwagon is offline   Reply With Quote