View Single Post
Old 01-16-2009, 06:09 PM   #8
Scooby Specialist
Member#: 38829
Join Date: Jun 2003
Chapter/Region: NWIC
Location: Tigard, OR
Not your usual 1997
Legacy GT


Finally talked to my builder, who tells me the motor is done and ready for pickup.

Sounds like I'll end up at 10.26:1, based on the mill specs he gave me and the TWE spreadsheet. He ended up decking the block .010" which brought the piston at TDC to deck height, and the heads .017" (seemed like a lot to me...?). So that's .85:1 higher than stock. I was hoping for low 10's (CR NOT 1/4 mile, haha) so should be a noticeable power increase.

Motor is going in tomorrow! May Kenji Kita be with me...

* Registered users of the site do not see these ads.
fastenova is offline   Reply With Quote