View Single Post
Old 04-21-2022, 10:23 PM   #1
Njoe
Scooby Newbie
 
Member#: 430939
Join Date: Sep 2015
Default Subaru outback xt 2009 5mt

hey guys so i was replacing my front diff axle seals today and totaly managed to destory the retainer ring that the diff seal sits in. i tried some stupid method i learned when working on my miatas to remove seals with a specialized tool and it basically wrecked the mating surface in two spots. now under load it sprays gear oil through that area.

my question is:

Is it possible to replace the retaining/preload ring without messing up the preload. obviously i would mark the location and match up once out of car. the car as 170k on current 5mt and shifts like brand new. trying to keep it that way!

iv'e included the part in question to hopefully make what im asking more clear:

https://ibb.co/GxkKjWk

that is the ring im trying to replace with a new unit
* Registered users of the site do not see these ads.

Last edited by Njoe; 04-21-2022 at 10:26 PM. Reason: img
Njoe is offline   Reply With Quote