View Single Post
Old 04-15-2008, 12:47 AM   #1
garinhash
Scooby Newbie
 
Member#: 149670
Join Date: May 2007
Location: Santa Rosa
Vehicle:
2019 WRX Limited
Lapis Blue

Default morette wiring help....again(high beams only)

ok, so i have some morette lights for my 02' bugeye, they were RHD lights, i opened up the projectors and flipped the plate inside and sealed them back up so now they project as LHD lights.
now i am trying to do the wiring, i have more or less figured out the wiring for the low beams, but the fog lights wont turn on and the high beam indicator stays on so i think it has something to do with the ground.
i have a few wires that im not sure what they do.
there are 2 wires(red / brown) that i believe connect to each other and go across the car from light to light.
the high beams will not light up so i have a feeling something about the last few wires will fix it
while i was trying to figure out how the wiring goes sometimes the light(not sure from where) would make a very nasty buzz noise, i guess the buzz had something to do with the high beams.
there are 2 other wires(both red and brown as well) i am not sure where they go... could these go to the battery + and -
* Registered users of the site do not see these ads.
garinhash is offline   Reply With Quote